Cascade Ultra Pima, color 3776 Pink Rose. I bought 10 skeins of the yarn at a lys that is closing this spring. The yarn wpi was about 18 epi, so I chose a sett of 12 EPI for a single layer, thus 24 epi for a double thickness. I used 12 dent reed with 2 ends per dent.
If you're interested in trying this, here's the draft:
Remember you are weaving double weave so it takes two picks for one complete pass. It's also why the draw down on the photo looks nothing like M's & O's.
Start throwing the shuttle from the left hand side. Your center fold is your right hand selvedge. I used a temple and used a "floating selvedge" style thread with the 4 end threads on the right hand edge of the weaving. They were two colors of 8/2 cotton and went through the heddles and reed with the threads, but were weighted separately. Those threads were pulled out of the web when the cloth came off the loom.
It's wise to check periodically to make sure you are getting two distinct layers. At the beginning of weaving, I used a large stick shuttle to slide between the layers when I advanced the warp. I also used a mirror set up at the left side of the loom to make sure my shed was clear for the bottom layer:
On the loom the blanket measured 38" wide and 46" long. After washing it is 35" wide and 43.75" long.
Here's a trick that I picked up from Jason Collingwood, though I think he does this for different reasons. At the beginning of weaving, I hate that my weft yarn slips down and gets caught on the tie-on rods and sometimes even the brake handle while I am trying to establish a rhythm with my treadling sequence.
See the loop of weft caught down there left of center on the photo? Grrr...
More opportunities for the same on the right side of the loom. Double grrr....
The answer to the problem:
Simply drape an old bath towel or pillow case under the web and over the ends of the rods that can catch the weft. Yay!!! Now I can get a rhythm established.
It's embarrassing how many years of weaving it took for me to figure that out.
When you really look closely at the blanket (as in hold it up to a backlight), you can tell where the center of the weaving is....the sett is just a little bit less dense. If I were to do this again, I would adjust the temple about 1/2" narrower and that might remedy the problem.
So here's a parting shot, from a slightly different angle:
And wasn't it lucky that I found a polyester binding that matched the yarn?
Oh...btw, I'm told they are expecting a girl. But you probably figured that out by now.